Charging The Flexmike - Lightspeed Redcat User Manual

Charging the Flexmike

BEFORE USE, THE FLEXMIKE SHOULD BE CHARGED
It will take 8-9 hours for the Flexmike to obtain a full charge. A fully charged
Flexmike will last for up to 8 hours of use. If microphones are used daily, they
should be charged each night.
When properly inserted into a cradle charger, the power status light will glow
red and the red light on the Flexmike power button indicates the battery pack
is charging. The power status light will glow green to indicate that charging is
complete and a full charge has been reached.
Replacement lithium polymer battery packs may only be purchased through
Lightspeed Technologies (part # 77-L3.7V-A). Do not attempt to charge with other
battery packs. They can overheat and expand creating a significant hazard and
damaging the microphone (this is not covered by warranty).
ATTACH LANYARD
Hang the Flexmike on the lanyard opposite
the magnetic clasp.
17
NOTE: If Activate Station was purchased with your system, please refer to page 24 for charging instructions.
CONNECT CRADLE CHARGER
Plug power cord into the cradle charger and
then plug the AC end into an electrical outlet.
CHARGE FLEXMIKE
Place the Flexmike into the cradle.
The LED on the Flexmike power light will glow
red indicating charging has started.
When charging is complete, the power status
light will glow green.