Power Supply 25V - Digi 700 Series Service Manual

Power supply 25v (LS200-24)
The output (voltage) adjustment trimmer should not be adjusted. This is pre-set to the correct output
voltage for the labeller
Set power supply output
voltage to 25v
This PSU supplies 25v onto the labeller board which will
then supply:
The thermal head
The cooling fan (for stepper motor)
Solenoid valve operation
25v PSU Backing paper take-up motor
Image from
Applicator fans
Signature
Thermal head heaters (standard fitment on Signature)
labeller
NOTE: The standard manufactures output voltage
for this power supply is 24V.
The power supply is reset to 25V for this labeller
application therefore the adjustment trimmer should
not be adjusted. This is pre-set to the correct output
voltage for the labeller
The input voltage to this power supply is 100-240vAC.
This voltage is obtained from the labeller mains
terminal connection inside the main electrical cabinet.
The output is:
Voltage = 25Vdc
Max output power = 200 watts
Max output current = 8.4A
25v PSU
25v PSU
2-47
HI, MI, WI-700 service manual - 2 - component parts
To PL11 on labeller board
+25v to pins 3 & 4
0v to pins 5 & 6
Mains power from
electrical cabinet
Issue 9 04/2020