Labeller - Changing Thermal Head Size - Digi 700 Series Service Manual

Labeller - Changing thermal head size

If the thermal head size on the labeller is to be changed, a setting in the Console or Worldview software
needs to be changed.
This setting specifies the number of dots across the thermal
head.
For 700 console software go to: Service menu / Labellers and select the thermal head option
For Worldview software go to: Service menu / Labeller setup / Service / Control - head dots
NOTE: if changing the thermal head size on a Signature labeller, the thermal head carrier plate will need
to be changed or modified as the location pins are in different positions for the 80mm & 108mm thermal
head - refer to information on page 4-43
Important: only use the specified values given in this instructions for the Digi
Europe supplied 108mm & 80mm thermal head, no other value should be used.
HI, MI, WI-700 service manual - 4 –servicing
Setting for 108mm head is 1280
Setting for 80mm head is 960
On the screen displaying the value, touch the
figures under 'Dot width' (for console) or next
to 'Head dots' for Worldview
80mm head = 960
108mm head = 1280
Enter the required value, touch 'ok' / Save
and exit to the operation screen.
This value change is required so the text and
information on the label format is centralised
to the new size thermal head.
4-89 Issue 9 04/2020