Table of Contents
Advertisement
Safety- your responsibilities
In normal operation, it is essential that the scale cover, protective covers or panels are in place.
The conveyors should be fitted and in their correct place for the machine to operate.
Always stop the conveyors and disconnect the mains electrical and air supplies when making adjustments,
cleaning and setting the machine.
Ensure all stray objects are removed and the conveyors are clear before restarting the machine.
Ensure that the machine is switched off and disconnected from the electrical and air supplies before
removing any cover or panel.
The warning label shown below will be visible on covers that can be removed to access live parts.
Only qualified service engineers should access these parts
Electrical safety
This machine is fully earthed to current standards and fitted with a three-conductor power lead.
It is essential that the power lead earth conductor be connected to a good and proper earth point, which is
also used for adjacent and associated equipment.
The machine is protected by fuses in the live/phase power line. In countries where the machines power
plug can be inserted in the power socket in two orientations, great care must be taken to ensure that the
live/phase pin of the plug is inserted in the live/phase receptacle of the socket. In the event of any fuse
going open circuit, the cause should be rectified and the fuse replaced with one of the correct specification.
If a fuse is replaced by one not conforming to the specification, the result could be damage to the machine
or an electric shock to any person in contact with it.
The primary fuse can be found inside the electrical cabinet (lower left position). Ensure mains power is
isolated from the machine and using a small flat blade screw driver unclip the fuse holder complete with
fuse
HI, MI, WI 700 service manual - 1 - Installation
For service engineers only
If working on live equipment, safety
glasses should be worn
1-6
Issue 9 04/2020
Advertisement
Table of Contents
