Access To Rear Of Labeller - Digi 700 Series Service Manual

Servicing & adjustments

Access to rear of labeller

The complete labeller assembly can be rotated through 90° to gain access the rear of the labeller
HI, MI, WI-700 service manual - 4 –servicing
Under the labeller, between the labeller and side
frame, unscrew & remove the screw in the support
plate
Unscrew & remove the 4 screws in the rear post, circled in red
below
NOTE: do not remove the central screw
Support the labeller and rotate the assembly
toward the end of the outfeed conveyor
Re-tighten central screw to secure into upright
position
4-114
Central screw
This screw acts as the
pivot point, therefore,
loosen this screw just
enough to allow the
rotation of the labeller
Issue 9 04/2020