HI, MI, WI-700 service manual - 2 - component parts
Platen roller option - Signature labeller
A platen roller option can be fitted to the Signature labeller instead of using the wear strip (near edge)
assembly
If near edge printing is not required or the labeller is to used with thermal ribbon the platen roller kit option
can be fitted.
To ensure good quality printing the platen roller should not have any damage to its surface material or
worn giving a recess in the material.
The platen roller should rotate freely between its two end bearings
Refer to the service section on replacement of these parts
2-42
Issue 9 04/2020