Ball Plunger Lock Tension - Digi 700 Series Service Manual

Signature labeller - Maintenance of centralizer label reel

Ball plunger lock tension

HI, MI, WI-700 service manual - 4 –servicing
The front reel disc is held in place by three sprung ball
plungers.
If the locking tension is too loose or tight, the height
position of the ball plungers can be adjusted.
With the front reel disc remove the ball plungers can be
seen
Using the three holes in the back of this assembly and a
flat blade angled screwdriver, the position of each ball
plunger can be adjusted
Removing front ring
Screw in two M3 screws into the centralizer guide pin ends
4-96
If appropriate tool is not available,
the front ring can be remove from
the shaft for adjustment
Issue 9 04/2020