Connections Inside Electrical Cabinet - Digi 700 Series Service Manual

Connections inside electrical cabinet

HI-700 - The labeller conduit, power lift motor cable & conveyor safety switch wire needs to be fed into the
rear of the electrical cabinet.
MI-700 / WI-700—normally the labeller, power lift motor and conveyor safety switch remain connected for
transportation, therefore no install connections for these cables is required. If re-connections are required
follow the same process as the HI-700
HI, MI, WI 700 service manual - 1 - Installation
Power lift cable, two entry points for
twin labellers
Outfeed conveyor safety switch wire
Air pipe position - two positions for twin
labellers
Labeller conduit position
Labeller conduit
Air pipe to the air regulator
Ethernet cable to be connected to the hub
Mains power - L, N, E to the 240v terminal rail
Ground wires to the cabinet (3 wires, 3rd wire
not shown)
Grey (two core) cable—no connection required
Feed the conduit into the cabinet through the
rear cable gland
1-12 Issue 9 04/2020