Satel INT-TSH2 Installer Manual page 35

SATEL
Arm mode review [Arm mode check.] – if this option is enabled, tap and hold for 3 seconds
the key to display information about the partition state. This function is not available
when the "Grade 2" option is enabled.
Alarm messages
Partitions [Part.alarm msg.] – if this option is enabled, messages on partition alarms will be
displayed (they contain the name of partition).
Zones [Zone alarm msg.] – if this option is enabled, messages on alarms from zones will be
displayed (they contain the name of zone). The zone alarm messages have the priority.
Alarms
PANIC alarm – if this option is enabled, you can trigger a panic alarm from the keypad by
using a widget.
silent [Silent panic] – if this option is enabled, the panic alarm triggered from the keypad will
be a silent one, i.e. the keypad will not indicate it, there will be no audible signal, but the
alarm will be reported to the monitoring station. The silent panic alarm is useful when the
control panel is sending events to the monitoring station, but unauthorized persons should
not be aware of the alarm being triggered. This option is available when the "PANIC alarm"
option is enabled.
FIRE alarm – if this option is enabled, you can trigger a fire alarm from the keypad by using
a widget.
MEDICAL alarm – if this option is enabled, you can trigger a medical alarm from the keypad
by using a widget.
Alarm 3 incorrect codes – if this option is enabled, entering incorrect code three times will
trigger the alarm.
Auto-backlight
Entry delay in part. – if you select this option, the keypad will be woken up when the entry
delay countdown begins in a selected partition.
viol. of zone – if you select this option, the keypad will be woken up when a selected zone is
violated.
no – if you select this option, the keypad will be woken up only when the user taps the
screen.
Wake-up – the way the keypad will respond to the wake-up (after a tap on the screen by the
user or occurrence of a specified event in the system):
Screensaver – screensaver will be displayed.
User screen – user home screen will be displayed.
Screensaver – if this option is enabled, the keypad screen is turned off after 10 minutes of
inactivity.
Keypad data
Go to this tab to configure the settings that are stored in the keypad. These settings can only
be configured in the DLOADX program.
The buttons located on the bottom of the window apply to all settings that are stored in the
keypad.
Read – click to read data from the keypad.
Write – click to write data to the keypad.
Quit – click to cancel the reading / writing of data.
INT-TSH2 33