Table of Contents
Advertisement
SATEL
The procedure described above applies to the keypad with factory default settings.
You can configure the keypad so that the access to the user screen is code-protected
(a keypad will open before the user screen is displayed).
Address setting in the VERSA system
1. Tap
"This LCD address (n, 0-5)" will be displayed in all keypads [n – keypad address; 0-5 –
range of supported addresses] (Fig. 12).
2. Enter the new keypad address and tap
Fig. 11. Terminal displaying the service menu.
. The "Keypads addr." function will start. The message
Fig. 12. Address setting.
INT-TSH2
. The keypad will restart.
11
Advertisement
Table of Contents
Need help?
Do you have a question about the INT-TSH2 and is the answer not in the manual?