Table of Contents
Advertisement
SQVEx 05.2
Operation
Backlight
7.3.1.
Menu layout and navigation
Groups
ID
Group selection
Direct display via ID
48
SQVEx 14.2/ SQRVEx 05.2
Push buttons
Navigation sup-
port on display
[4] C
Setup
Esc
The display is illuminated in white during normal operation. It is illuminated in
red in case of a fault.
The screen illumination is brighter when operating a push button. If no push
button is operated for 60 seconds, the display will become dim again.
The indications on the display are divided into 3 groups:
Figure 51: Groups
[1]
Start menu
[2]
Status menu
[3]
Main menu
Status menu and main menu are marked with an ID.
Figure 52: Marking with ID
S
ID starts with
S
= status menu
M
ID starts with
M
= main menu
It is possible to select between status menu S and main menu M:
For this, set selector switch to 0 (OFF), hold down push button C for approx. 2
seconds until a screen containing the ID M... appears.
Figure 53: Select menu groups
You return to the status menu if:
the push buttons on the local controls have not been operated within 10 minutes
or by briefly pressing C
When entering the ID within the main menu, screens can be displayed directly (without
clicking through).
SQRVEx 14.2 Control unit: electronic (MWG)
ACVExC 01.2 Modbus RTU
Functions
Enter Main menu
Cancel process
Return to previous display
Advertisement
Table of Contents
