Tools Menu; Version - ABB RELION REB500 Operation Manual

1MRK 500 132-UUS Rev. B
A checkmark appears next to the menu item, Installation mode is displayed on the status line at the
bottom of the screen and the Installation mode dialog box opens.
Click on Installation mode in the Testing menu to reset the installation mode. The checkmark in the
menu item is reset.
IEC18000548 V1 EN-US
Figure 59:
Table 18:
Button
Delete data base in the
protection system
Restart the protection system
Start debug mode
Read Traceability information
4.9

Tools menu

4.9.1

Version

This menu item is for administering the database for the specific protection system, which contains
information such as settings, event texts, configuration of the binary inputs and outputs etc. Parts of the
database can be edited on the PC using HMI500 and then downloaded to the protection. The database
has a version number and index that are displayed in the HMI main menu.
Distributed busbar protection REB500
Operation manual
Installation mode menu
Buttons in Installation mode menu
Description
All the data in the protection system are deleted, that is the project
database (MDB file) in the protection system is deleted.
Reinitializes the protection (CU and all BU's)
In the debug mode, the protection system generates additional internal
program events. As a rule, the debug mode is only used by the ABB
engineering department for test purposes.
The system info, the order codes of the central unit and the bay units
(the decoding of the order code is shown in chapter Ordering for
customized IED in the REB500 Product Guide), the hardware data
(type, serial number, revision index, date of manufacture etc.) and the
software data (version) are uploaded from the protection equipment
and added to the HMI500 report section (see menu item Tools /
Reports/Traceability data ).
© 2020 - 2022 Hitachi Energy. All rights reserved
13000018_2-IEC18000548-1-en.vsdx
GUID-60C6DF97-23F3-45C5-AAF2-F05EC227AB6A v2
Section 4
HMI500
71