Uninstallation; Starting Hmi500 - ABB RELION REB500 Operation Manual

Section 4
HMI500
directory. Clicking Next starts the installation. An HMI500 directory and program icon HMI500 x.xxll are
created in the Windows start menu, x.xx signifying the program version and ∣∣ the language.
1. Insert the Product media into a suitable port.
2. Select the Product medias directory, which is labeled Relion® REB500.
3. Select and run the shortcut Start_here.exe to start the REB500-Navigator.
4. After the REB500 Navigator has opened, select the preferred language and enter the HMI500 link,
which is placed under the Navigator section Software. The software installation procedure should
start now.
4.3.2

Uninstallation

1. Open Windows control panel and select Add/remove programs.
2. In the list of programs, select the entry for HMI500 and click OK to remove the program.
4.3.3

Starting HMI500

The first screen to appear after starting the operator program is the System login dialog box:
IEC18000288 V1 EN-US
Figure 2:
The program can be run in a read only mode by checking the Read only check box, that is, the data can
be viewed but not changed.
12
The program screens in this section are based on a typical application. Depending on
the power system configuration and the options configured while engineering your
system, certain menus may be missing or the display appears different.
System login dialog box
© 2020 - 2022 Hitachi Energy. All rights reserved
1MRK 500 132-UUS Rev. B
GUID-BC60CAA7-94DA-47CC-8E29-384811D8F36E v2
GUID-2084991B-D391-447C-B145-20B9AA6081BC v2
GUID-1F1B41E7-767F-47F9-9E29-8661BD0849E3 v3
15000019-IEC18000288-1-en.vsdx
Distributed busbar protection REB500
Operation manual