Table of Contents
Advertisement
Safety
Warning
ALL PRODUCT(S) MUST BE INSTALLED BY A SUITABLY COMPETENT ELECTRICIAN CONSIDERING THEIR
INTENDED USE AND IN ACCORDANCE WITH THE CURRENT EDITION OF BS 7671 (IET WIRING REGULATIONS).
Notice:
To prevent potential overheating from loose connections the installer shall check connections are
tightened to the torque levels stated in these instructions prior to energising this board. This check should
include factory made connections which may have loosened in transit.
Tools Needed
PH,PZ,Torx Screw Driver
Warning! Installation by person with electrotechnical expertise only.
▪
Avoid contact with energized electrical circuits.
▪
Treat all electrical components as if they are energized.
▪
Disconnect all power sources.
▪
Use tools with non-conducting handles.
▪
Remember PPEs (Personal protective equipment).
▪
Make sure that the incoming and outgoing circuit breakers are in the OFF position.
▪
Follow instructions for assembly guide.
▪
All connections/methods should meet all national/local electrical codes as well as company specific methods
▪
or procedures. Failure to do so may result in damage to the equipment, and or personal injury.
M5,M6 Hexagonal Wrench
M8 Hexagonal Key
WARNING
Hammer
1
Advertisement
Table of Contents
