Maritime G6100 Operation Manual page 91

Water Monitoring System
MI6100-0001
System Type Water Monitoring System
Task: Turbidity Wiper Blade Replacement
Task This instruction identifies the location and replacement of the Wiper Blade.
Wiper Blade replacement must be carried out by a trained technician.
description:
Difficulty 1-5 Overhaul Interval
If necessary
Spare Parts
Part no: Description:
02386 Wiper blade spare part set of 4pcs
Instructions
Steps
1. Turn OFF the turbidity sensor by switching OFF all
automatic fuses in the monitoring unit (refer to el-
documents).
2. Place a cup under the calibration fluid drain off to collect
the discharge (underneath the cabinet).
3. Turn VALVE 3 to STOP position and VALVE 2 to
DRAIN position for WM units. Turn INTERNAL VALVE
to DRAIN position and CLOSE the BALL VALVE for
WMRTU units.
4. Loosen the black union nut
the wiper unit (B) – park it.
5. Pull wiper blade (C)
discard the wiper blade
6. Ensure wiper arm is undamaged & at a 90
bottom surface of the wiper unit. Ensure slot
and parallel.
7. Taking care not to damage the new wiper blade, slide it
into the wiper arm slot (D), ensuring blade edge is facing
outwards.
8. Turn ON the turbidity sensor by switching ON all
automatic fuses.
9. Observe the wiper arm
cut-out position(F).
10. Ensure that the O-ring
positioned correctly.
11. Refit the wiper unit
at the cut-out position
by hand.
12. Turn VALVE 3 to Run position and VALVE 2 to Run
position for WM units. Turn INTERNAL VALVE to RUN
position & OPEN the BALL VALVE for WMRTU units.
Notes:
Ver.5.0 – Revision March 2022
(A) on the top and remove
out of slot (D) in wiper arm
angle to the
0
(D)
(E) rotating and stopping at the
(G) is undamaged and
(B) making sure that it is orientated
(F) and tighten the black union
Estimated Time Consumption
5 min
Tools
Qty. Item:
1 None
Photos:
(E) and
is straight
(A)
MI6100-0001
Page 91 of 110