Routine Maintenance - Maritime G6100 Operation Manual

Water Monitoring System

8 Routine Maintenance

WARNING/ATTENTION
• To avoid risk of corrosion, always clean up the water spill immediately.
• Do not use sharp or hard tools to clean the lenses. Use the cleaning pads for black
fouling and use a tissue soaked with water to remove salt deposits.
• The PAH and Turbidity sensor modules use UV and IR light. Please do not stare into
the lenses – it can cause damage to your eyes.
Note
The intervals stated below are only general guidelines and must be adjusted based on
specific system experiences. The intervals are based on optimum conditions and
failure to comply with system specifications can impact intervals.
Description
G6110 PAH sensor
Validation of PAH sensor
Calibration of PAH sensor
Factory Calibration of PAH
sensor
Visual check to see if
cleaning is needed:
• PAH sensor
• PAH measuring chamber
& bushing
Cleaning of PAH sensor,
measuring chamber &
bushing
Internal Light Source
Replacement at Factory
PAH Chamber
Replacement
Ver.5.0 – Revision March 2022
Planned Maintenance Program
x
x
x
x
x
x
x
MI6100-0017
Page 51 of 110