Maritime G6100 Operation Manual page 66

Troubleshooting
Trouble
Hose pump: Pump hose
pulled into the pump
housing
The pump does
not start up
Possible Cause →Action
→ Too high inlet pressure → Reduce inlet pressure.
→ Pump hose filled with deposits → Clean or replace the pump hose.
→ Flange insufficiently tightened → Retighten flange
→ Insufficient grease → Top lubricant
→ Insufficient motor performance → Check motor and replace if
necessary.
→ Blockage in the pump → Check power supply. Start occurs at a
minimum of 10 Hz.
→ Blockage in the pump → Check if the suction or discharge side is
blocked. Remove blockage.
Page 66 of 110