Table of Contents
Advertisement
Installing Firmware with Firmware Loader
Use the Firmware Loader utility to upload firmware to the receiver when connected directly
to the device.
1.
Connect the host device to the front panel USB port.
2.
Open Firmware Loader and establish a connection between the computer and the
device. The Add Device... dialog box opens.
Figure 29.
3.
From the
NOTE: If
4.
From the
5.
Depending on the connection method, additional options appear. Make the appropriate
selections for the current connection method.
6.
Click the
7.
Click the
box opens.
8.
In the Open dialog box, navigate to the new firmware file, which has an .S19 extension,
and select it.
ATTENTION:
other extension is not a firmware upgrade for this device and could cause the
device to stop functioning.
ATTENTION : Les fichiers firmware valides doivent contenir l'extension fichier S19.
Un fichier avec n'importe quelle autre extension n'est pas une mise à jour de
firmware pour cet appareil et l'appareil pourrait arrêter de fonctionner.
9.
Click the
10.
Click the
are listed in the Firmware Loader main window.
11.
Click the
12.
Close Firmware Loader when the
Progress
Add Device... Dialog Box
drop-down list, select
Device Name
is not available, select
XTP R HWP 201
drop-down list, select the method of connection.
Connection Method
button.
Connect
button in the New File Firmware (Optional) section. The Open dialog
Browse
Valid firmware files must have the file extension .S19. A file with any
button. The Browse dialog box closes.
Open
button. The Add Device... dialog box closes and the device and firmware
Add
button to start the upload process.
Begin
Remaining Time
column is
, and the
100%
Status
XTP R HWP 201 Wallplate Receiver • Reference Information
.
XTP R HWP 201
.
XTP R HDMI
field shows
00.00.00
field is
.
completed
, the
34
Advertisement
Table of Contents
