Table of Contents
Advertisement
Installing the Mud Ring
Backing Clip
Mounting Screw
Rotate the backing clip
out of the way to insert
the mud ring into the wall.
Figure 2.
1.
Place 1.25 inches (3.18 cm) long or 0.75 inch (1.90 cm) #6-32 thread machine screws
through the large holes in the two corners of the mounting bracket. Use the shortest
possible screw needed.
2.
Loosely fasten the mounting backing clip on the end of each screw.
3.
Insert the mounting bracket into the opening in the wall.
4.
Rotate each backing clip so that the tab is behind the installation surface to hold the
bracket snuggly in place when the screw is tightened.
Mountint Surface
Backing Clip
0.75" #6-32 Screw
Figure 3.
NOTE: The backing clip can be installed as shown in Figure A or Figure B (see
figure 3).
5.
Use a cross-head (Phillips) screwdriver to fasten the screws and backing clips in place.
Installing the Mud Ring with Backing Clips
Mounting Surface
Backing Clip
1.25" #6-32 Screw
Figure A
Backing Clip Installation
XTP R HWP 201 Wallplate Receiver • Installation
Figure B
6
Advertisement
Table of Contents
