Transmitter Rear Panel - Extron electronics DTP DVI 4K 230 D Series User Manual

C
Audio input — Connect an unbalanced stereo audio source to this 3.5 mm mini stereo
jack for unbalanced audio input. Figure 5 shows how to wire the audio plug.
Tip
Left (+)
Ring
Right (-)
Figure 5.
D
RS-232 and IR (Control) pass-through connector — Connect a serial
communications port to this 3.5 mm, 5-pole captive screw connector for bidirectional
RS-232 communication and IR communication (see
Wiring
E
DDC Route switch — This switch selects either the remote or local DVI display as the
Display Data Channel (DDC) reference for EDID and HDCP communication.

Transmitter Rear Panel

B
Figure 6.
A
DC power input connector — Plug the included external 12 VDC power supply into
either this 2-pole connector or the power input connector on the receiver (see
Supply Wiring
B
Transmitter output port — Connect one end of a twisted pair cable to this RJ-45
output port.
ATTENTION:
•
•
Sleeve ( )
Audio Input Connector Wiring
on page 13 to wire the connector).
SIG LINK
DTP DVI 4K 230 D Tx
DO NOT
DTP OUT
CONNECT
TO LAN
DTP DVI 4K 230 D Transmitter Rear Panel Connectors
on page 11 to wire the connector).
Do not connect this device to a telecommunications or computer data
network.
Ne connectez pas cet appareil à un réseau de télécommunications ou de
données informatiques.
DTP DVI 4K 230 D Transmitter and Receiver • Introduction
RS-232 and IR Connector
A
POWER
12V
0.8 A MAX
Power
7