Table of Contents
Advertisement
Factory reset
5
Factory Reset — Click the
settings except for firmware.
NOTE: This is the same as the
command
on page 23).
Device Information panel
The Device Information panel on the right side of the software screen displays device
information and settings.
General Information section
1
Model — Displays the device model.
2
Firmware Version — Displays the full firmware
version.
Signal Information section
3
Signal Present — Indicates whether a signal is
present on the input.
4
Video Mute — Displays the mute status of the
video output.
Audio Information section
5
HDMI Audio — Displays the mute status of the
embedded digital audio on the HDMI output.
6
S/PDIF Audio — Not applicable to the
XTP R HWP 201.
7
Analog Audio — Displays the mute status of the analog audio output.
8
Analog Audio Volume — Displays the analog audio output volume level in a
percentage.
XTP R HWP 201 Wallplate Receiver • XTP System Configuration Software
button to reset the receiver to factory
Factory Reset
E
SIS command (see the
ZXXX
System reset
30
Advertisement
Table of Contents
