Installation
This section contains information for mounting, connecting, and wiring the XTP R HWP 201.
Topics in this section include:
•
•
•
•
•
•
Installation Overview
The XTP R HWP 201 can be installed into the provided mud ring or a UL Listed metal
electrical junction box.
NOTE: If using a junction box, use a metal one only.
1.
2.
Installation Overview
Installing the Metal Junction Box or Mud Ring
Rear and Side Panel Connectors
Mounting the XTP R HWP 201
Front Panel Connectors
Making Connections
Prepare the mounting surface.
CAUTION: Risk of personal injury. Failure to check the items listed below may
result in personal injury.
ATTENTION : Risque de blessure. La non-vérification des éléments listés ci-
dessous peut provoquer des blessures.
ATTENTION:
Failure to check the items listed below may result in property
damage.
ATTENTION : La non-vérification des éléments listés ci-dessous peut provoquer
des dommages matériels.
Ensure there are no utility cables or pipes at the intended location that might be
•
damaged or cause injury when installing the device.
Check that the installation meets building, electrical, and safety codes.
•
Ensure there is sufficient space behind the device.
•
Choose a location that will allow cable runs without interference.
•
NOTES:
•
Cables may need to be installed in the wall or conduits before installation.
•
The mud ring does not require attachment to wall studs.
•
For metal junction boxes, refer to the manufacturer for more installation
requirements.
Cut a hole in the mounting surface (see
Surface
on page 5).
Cutting an Opening in the Mounting
XTP R HWP 201 Wallplate Receiver • Installation
4