Table of Contents
Advertisement
C
D
E
Making Connections
HDMI Connection
To secure the HDMI cable to the HDMI output
connector, use a tie clip and the front panel lance
punch.
1.
2.
3.
4.
RS-232 Over XTP port — To pass bidirectional serial or other control
signals between XTP-compatible devices, connect a control device to the
5-pole captive screw connector. The port includes only the 3 poles labeled
"RS-232."
IR Over XTP port — To transmit and receive IR signals (up to 40 kHz),
connect a control device to the 5-pole captive screw connector. This port
includes only the 2 poles labeled "IR" and shares the ground pole with the
RS-232 port.
NOTE: RS-232 and IR data can be transmitted simultaneously (see
RS-232 and IR Over XTP Communication
LAN connector — Connect a control device or device to be controlled to this LAN
connector for 10/100Base-T Ethernet communication through this pass-through port.
LEDs on this connector indicate link and activity status.
Configuration port — If desired, connect a host device to the front panel USB mini-B
Config port for configuring the receiver.
Route the tie clip through the front panel lance
1
punch (see
in the image to the right).
Plug the HDMI cable into the panel connection
2
(
).
Loosely place the included tie wrap around the
HDMI connector (
3
).
ATTENTION:
Connect and pull the tie
wraps until they are secure. Do not
overtighten.
ATTENTION : Connectez et tirez les
serre-câbles jusqu'à ce qu'ils soient
sécurisés. Ne pas trop serrer.
Use pliers or similar tools to tighten the tie
wrap, then remove any excess length (
on page 13 for wiring details).
A U
D I O
L
R
O V
E R
R S
X T
- 2 3
P
2
IR
T x
R x
G
T x
R x
L A N
A U
D I O
L
R
O V
E R
R S
X T
- 2 3
P
2
IR
T x
R x
G
T x
R x
L A N
4
).
2
2
XTP R HWP 201 Wallplate Receiver • Installation
RS-232
IR
Tx Rx G
Tx Rx
RS-232
IR
Tx Rx G
Tx Rx
H D
M I
O U
T
R
1
1
P W
S IG
D IO
A U
3
3
4
4
H D
M I
O U
T
R
P W
S IG
D IO
A U
11
Advertisement
Table of Contents
