Table of Contents
Advertisement
3.
4.
5.
6.
7.
Installing the Metal Junction Box or Mud Ring
Cutting an Opening in the Mounting Surface
1.
2.
4.
5.
6.
Install the mud ring or metal junction box in the mounting surface (see
Mud Ring
on page 6 or
Installing a UL Listed Metal Junction Box
Route and connect cables to the rear and side panel connectors (see
Panel Connectors
on page 8).
Mount the XTP R HWP 201 to the mud ring or metal junction box (see
XTP R HWP 201
on page 9).
Connect inputs to the front panel connectors (see
page 10).
Supply power to all connected devices.
Using an appropriate template or the mounting enclosure as a guide, mark the area
of the wall that will be cut with a soft pencil (for the provided mud ring, see
Template
on page 35).
NOTE: Check with the manufacturer of the metal junction box for specific
installation requirements.
Use a jigsaw or small hand saw to carefully cut away the material within the guidelines
drawn in step 1.
NOTE: If using a template or the mud ring as a guide for cutting the hole in drywall,
cut inside the guidelines to maximize the contact the mud ring makes with the
drywall.
If using a mud ring in a wall with insulation inside, remove at least 6 inches of the
insulation in all directions around the cutout.
NOTE: If a wall stud interferes with removing 6 inches of insulation around the
cutout, remove the insulation between the cutout and wall stud.
Check the size of the opening by laying the mud ring or metal junction box against it.
The mounting device should fit snugly in the opening.
If needed, use a saw, file, or sandpaper to enlarge the hole.
CAUTION: Risk of personal injury. Smooth the edges of the opening to avoid
personal injury during installation.
ATTENTION : Risque de blessure. Lissez les bords de l'ouverture afin d'éviter
toute blessure lors de l'installation.
Smooth the edges of the opening to avoid damage to the mounting.
ATTENTION:
ATTENTION : Lissez les bords de l'ouverture afin d'éviter d'endommager la
monture.
Front Panel Connections
XTP R HWP 201 Wallplate Receiver • Installation
Installing the
on page 7).
Rear and Side
Mounting the
on
Mounting
5
Advertisement
Table of Contents
