Housing (Front) - Remove - Perkins 1103 Disassembly And Assembly

SENR9779-02
Illustration 178
8. Check the end play for the idler gear. Refer to
the illustration 178 and refer to the Specifications
Manual, "Gear Group (Front)" for more information.
Illustration 179
9. Check the backlash between the idler gear and
the camshaft gear. Refer to the illustration 179 and
refer to the Specifications Manual, "Gear Group
(Front)" for more information.
10. Check the backlash between the idler gear and
the crankshaft gear. Refer to the Specifications
Manual, "Gear Group (Front)" for more information.
Note: The three cylinder engine can be equipped
with either the Delphi DP210 or the Delphi DPG fuel
injection pump.
Note: The four cylinder engine can be equipped
with the Delphi DP210, the Delphi DPA or the Bosch
EPVE fuel injection pump. The various types of fuel
injection pump have a different procedure for locking
the fuel injection pump shaft.
11. Install the fuel injection pump gear. Refer to this
Disassembly and Assembly Manual, "Gear Group
(Front) - Install".
12. Remove the timing pin for the crankshaft (3) and
remove the timing pin for the camshaft (4).
13. Lightly lubricate all of the gears with clean engine
lubricating oil.
End By:
a. Install the rocker shaft. Refer to this Disassembly
and Assembly Manual, "Rocker Shaft and Pushrod
- Install".
b. Install the glow plugs if the glow plugs were
previously removed. Refer to this Disassembly
and Assembly Manual, "Glow Plugs - remove and
Install".
c. Install the front cover. Refer to this Disassembly
g00944081
and Assembly Manual, "Front Cover - Remove
and Install".

Housing (Front) - Remove

Removal Procedure
Start By:
a. Drain the coolant into a suitable container for
storage or disposal.
b. Remove the fan drive. Refer to this Disassembly
and Assembly Manual, "Fan Drive - Remove and
Install".
g00944084
c. If necessary, remove the alternator. Refer to this
Disassembly and Assembly Manual, "Alternator -
Remove".
d. Remove the fuel injection pump. Refer to the
appropriate fuel injection pump within this
Disassembly and Assembly Manual, "Fuel
Injection Pump - Remove".
e. Remove the engine oil pan. Refer to this
Disassembly and Assembly Manual, "Engine Oil
Pan - Remove and Install".
f. Remove the gear group (front). Refer to this
Disassembly and Assembly Manual, "Gear Group
(Front) - Remove".
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
Disassembly and Assembly Section
NOTICE
83
i01964553