Front Cover And Lvps Pcb - Care Fusion Alaris Technical & Service Manual

Front Cover and LVPS PCB

Replacement Procedure
1 . Remove the 3 Tile Assembly .
2 . Remove the four Screws
3 . Disconnect the Cable Assembly Services LVPS (J3), Cable Assembly Services Power (J4), Cable Assembly Battery LVPS (J6) and the
Cable Assembly Tile LVPS (J5) from the LVPS PCB
C
4 . Remove the four screws
5 . Release the locking tabs for Molex connector (J2) and remove the Keypad Panel
6 . Remove the Front Cover Seal
7 . Reassemble in reverse order .
Refitting Note:
When replacing the Front Cover Seal, fit the Seal to both edges of the Front Cover . The flat edge goes against the side of the Front Cover
and the edge with the tube goes into the Front Cover recess . Ensure that all connectors are pushed fully home . Torque screws to 45cNm .
Fit the Front Cover to the extrusion and torque to 170cNm .
B
LVPS PCB
Item Description
a M4x20 Pan HD Torx A2 BN5653
b Assembly PCB LVPS
c M3x8 Pan HD Torx A2 ISO14583
d Washer M3 Plain Z+C
e Flat Washer Nylon M3 TO ISO 7089
f Cover Front AGW
g Label AGW Front
h Seal Front Cover AGW
A
securing the Front Cover Assembly .
B
.
D E
, four washers and
H
.
Ground Wire
C
Screws (x4)
D
E
Washers (x3)
J1
1000SM00015 Issue 8
and Ground Wire securing the LVPS PCB to the Front Cover
G
F
Front Cover
H
Seal (x2)
Washer
LVPS and Front Cover Assembly
A
Screws (x4)
G
Keypad
Alaris® Gateway Workstation
Corrective Maintenance
flexi tail .
J5
J6
J4
J3
Part Number
1000SP01217
1000EL00628
1000SP01217
1000SP01215
24/72
F
.