Table of Contents
Advertisement
5 Corrective Maintenance
Introduction
• Ensure the Workstation is disconnected from the AC power supply and switched off before attempting to
A
service . To isolate the Gateway from mains supply remove the mains connector from the source socket . The
Gateway should be positioned to allow access for disconnecting the mains connector .
• The Workstation contains static-sensitive components . Observe strict ESD precautions at all times
• Only use CareFusion recommended spare parts
• Following all spare part replacement and repair activities, testing must be performed in accordance with the
Performance Verification Procedure (PVP), see Chapter 2, 'Routine Maintenance'
Note: The Alaris®
VP Plus Guardrails®
Volumetric Pump will
only be recognised
when using software
variant V1 .1 .6 and
above .
1000SM00015 Issue 8
Alaris® Gateway Workstation
Corrective Maintenance
20/72
Advertisement
Table of Contents
