Error Tone Output Setting; Mixer Settings - Fostex PD204 Owner's Manual

Chapter 5: Recording/Playback

Error tone output setting

During recording, if the unit encounters the following problems, the error tone is output for
warning.
1. A write error happens during recording.
2. The input amplifier is clipped during recording.
3. The battery voltage drops below the specified level.
4. The remaining volume of a disk (or partition) becomes less than the specified volume.
You can make error tone output setting via the "Error tone" item in the "SYS SETUP" menu of
the MENU mode (see page 160).
The mixer section provides the function for mixing four analog input sources to the stereo bus.
You can record the stereo bus signals to stereo L/R tracks. (When you record a digital input
signal, the signal is directly recorded to the stereo L/R tracks without being routed to the mixer
section.)
The four input channels of the mixer section provide controls for the analog input signal,
including the filter, limiter, etc.
The following diagram shows the signal flow of the mixer section of the PD204.
Read the explanation described in the following pages and make mixer settings appropriately.
ANALOG IN 1-4
P48V
T12V
78
Location Recorder Model PD204

Mixer settings

LINE/MIC
AMP
GAIN
LIMITER
HPF
AD
PHASE
PFL
ST BUS
SEND
PAN
ST BUS
MASTER
AUX IN L, R
LEVEL
SEL
DA
MONITOR
SEL
REPRO/
INPUT
SEL
FROM RECORDER
(REPRO DATA)
LIMITER
DA TO HP/MON SP
DA
ANALOG OUT
TO RECORDER
(2TRK FILE)