Selecting The Drive For Recording - Fostex PD204 Owner's Manual

Chapter 5: Recording/Playback
The PD204 is equipped with the DVD multi drive and hard disk drive.
Before recording, select the drive to which recording is made. By default, partition 1 (PT01) on
the hard disk drive is selected as the current drive.
To record to a DVD-RAM disk or another partition, select the desired drive by following the
procedure below.
In the procedure below, it is assumed that a formatted DVD-RAM disk is set to the DVD drive.
1) While stopped, press the [SHIFT] key to enter shift mode, followed by the [FILE SEL / DRV, PAT.] key.
The display changes to show the screen for selecting a drive. On the screen, the current
selection is initially highlighted.
<Note>: You can also bring up the screen for selection a drive (as shown above) by the
following methods.
1) While stopped, press the [SHIFT] key to enter shift mode, followed by the [ENTER/YES] key.
The display shows the MENU list screen for selecting the desired main menu.
2) Use the [MENU] dial to select "DRV/PAT SEL" and press the [ENTER/YES] key.
The display shows the screen for selecting a drive as above.
2) Use the [MENU] dial to select the desired drive (the DVD drive or a partition) and press the
[ENTER/YES] key.
The selected drive is loaded and the display shows the Home screen of the current drive as
below (in the both examples below, no recording has been made to the current drive).
<When the DVD drive is selected>
84
Location Recorder Model PD204

Selecting the drive for recording

SHIFT
POWER QUICK SET TIME
ON
OFF
SHIFT TC SET
AUX ST
C2
MONO
C1 L/M
MS R/S
PD204 LOCATION RECORDER
MONITOR
FILE SEL
DRV,PAT.
ENTER
YES
FILE SEL LIGHT EXIT
DRV,PAT CONTRAST BATT MENU
ACCESS
HDD DVD
<When partition 2 is selected>
space AB
1 2
GHI JK
4 5
PQRS TU
7 8