Table of Contents
Advertisement
DC-IN low voltage warning setting [DC-IN warning]
Using the "DC-IN warning" item, you can set the threshold low battery voltage for generating
the warning tone when an external battery is connected to the [DC-IN] connector.
When the battery voltage drops down to the threshold voltage for warning, you can hear the
warning tone via headphones.
1)
While the unit is stopped, press the [SHIFT] key followed by the [ENTER/YES] key.
2)
Use the [MENU] dial to select the "BATTERY SETUP" menu and press the [ENTER/YES] key.
The display shows the screen for battery-related settings.
3)
Use the [MENU] dial to select the "DC-IN warning" menu item and press the [ENTER/YES] key.
The current setting starts flashing. You can now select a voltage from the following.
4)
Use the [MENU] dial to select a desired option and press the [ENTER/YES] key to confirm
your setting.
5)
Press the [EXIT] key repeatedly until you exit the MENU mode.
<Note>:
When you make recording using the power supplied from the [DC-IN] con-
nector, if the power drops down to the threshold voltage, the warning message
appears on the display. And after a minute passes, the unit automatically stops
recording. However, if a battery is also mounted to the unit and the "Power priority"
item is set to "DC-IN", the unit automatically switches the power source to the bat-
tery when the warning message appears on the display so you can continue record-
ing.
Available options for a BMS battery
10.5V to 13.5V in 0.5V steps (the default is 13.0V)
* We recommend the following setting depending on the battery type.
For NiCd battery: 10.5V or higher
For Lithium Ion battery: 12.5 ~ 13.0V or higher
Chapter 8: MENU mode/BATTERY SETUP menu
Location Recorder Model PD204
Flashing
167
Advertisement
Chapters
Table of Contents
