Cueing Playback; Time Code Playback - Fostex PD204 Owner's Manual

4) Press the [PLAY] key to start playback.
The [PLAY] indicator is lit.
You can monitor the playback sound via headphones, the internal speaker or the
[ANALOG OUT] connectors.
5) To stop playback, press the [STOP] (or [PAUSE]) key.
<Note>:
to stop playback for saving battery power.
<Note>:
mode. The pause mode is automatically released after the pause release time has
passed and the recorder completely stops.
You can set the pause release time using the "Pause time" item in the "SYS SETUP"
menu of the MENU mode. The default pause release time is three minutes (see
page 149).
<Hint>
You can select how the recorder behaves after it finishes playback of an audio
file, using the "Chain play" item in the "SYS SETUP" menu of the MENU mode (see
page 163). By default, the recorder stops after playback ends. However, depend-
ing on your selection, it can pause at the beginning of the next audio file or
continue playback of audio files one after another.

Cueing playback

In the cue mode, forward or backward cueing (at up to 2 x speed) is possible.
During playback, pressing the [F FWD] (or [REW]) key enters the cue mode and you
can monitor audio at 2 x speed.
To cancel the cue mode, press the [PLAY] mode.

Time code playback

Recorded time code is played back together with audio and can be output from the
[TIME CODE OUT] connector.
To output recorded time code from the [TIME CODE OUT] connector, set the "Sel. TC
Out" item in the "TC SETUP" menu of the MENU mode to "Repro". By default, the "Sel.
TC Out" item is set to "Repro".
If the "Sel. TC Out" item is set to "Gen", set it to "Repro" (see page
how to set the "Sel. TC Out" item).
<Note>: If the "Sel. TC Out" item is set to "Gen", always the internal TC generator
time code is output from the [TIME CODE OUT] connector.
In the "TC SETUP" menu, the following menu items regarding time code playback are
available. Set these item appropriately.
1) LTC start time setting ("Edit LTC start") -> page
2) Time code output setting in pause mode ("Pause TC") -> page
3) Userbit setting of repro. time code ("Rep TC Ubit") -> page
While operating the unit on battery, we recommend using the [STOP] key
If you stop playback using the [PAUSE] key, the recorder goes into pause
Chapter 5: Recording/Playback
185
186
Location Recorder Model PD204
183 for details about
187
97