Tsgen:configure:stopdata - R&S SMCVB-K157 User Manual

®
R&S SMCVB-K157
:TSGen:CONFigure:STOPdata <StopData>
Ensures that a standardized TS data stream is always output at the TS output at the
rear of the R&S SMCV100B.
Parameters:
<StopData>
Example:
Manual operation:
:TSGen:CONFigure:STUFfing <Stuffing>
Activates nullpacket stuffing.
Parameters:
<Stuffing>
Example:
Manual operation:
:TSGen:CONFigure:TSPacket <TSPaket>
Sets the structure of the generated test packets in pause or stop status.
Parameters:
<TSPaket>
Example:
Manual operation:
:TSGen:CONFigure:TSRate <TSRate>
Sets the output data rate of the player.
User Manual 1179.4686.02 ─ 01
TTSP | NONE
*RST: NONE
See Example "Configuring and monitoring TS player output"
on page 60.
See "Stop Data" on page 29
1 | ON | 0 | OFF
*RST: 0
See Example "Configuring and monitoring TS player output"
on page 60.
See "Nullpacket Stuffing"
H184 | H200 | H204 | S187 | S203 | S207
S187|S203|S207
A sync byte (0x47) followed by 187/203/207 payload bytes.
H184|H200|H204
A sync byte (0x47) followed by three header bytes and
184/200/204 payload bytes.
*RST: H184
See Example "Configuring and monitoring TS player output"
on page 60.
See "Test TS Packet" on page 30
Remote-control commands
TSGen subsystem
on page 29
65