R&S SMCVB-K157 User Manual page 38

®
R&S SMCVB-K157
2. Optionally, if supported, activate "Stuffing" to adjust the TS data rate.
3. Specify IP TS channel properties, e.g. for "IP TS Channel > 1":
a) Define the input type, e.g. "Type > Multicast".
b) Specify the "Multicast Address", that is the destination IPv4 address of the IP
c) Specify the port, that is the destination port of the IP connection.
d) Specify the
e) Optionally, to check availability of the "IGMPv3 Source Address", click "Ping
f)
g) Activate the IP channel, select "Input IP > On".
The R&S SMCV100B is prepared for receiving IP TS data, that is input at the "IP
Data" connector.
Monitor IP data stream properties in the "Info" side tab, see
monitor external IP input
User Manual 1179.4686.02 ─ 01
connection.
Note: Use the destination address also in the IP data source, e.g. a stream
program.
Note: Use the destination port also in the IP data source.
IGMPv3 source address, that is the source IPv4 address of the IP
connection.
A source address different from "0.0.0.0" accepts only data originating from the
specified IP address.
Source Address"
● If "Ping Result > Ping: Successful", the source address is available.
● If "Ping Result > Ping: Transmit Failed. Destination Host Unreachable", try
another address.
Optionally, specify a name for the IP connection, e.g. "Alias > Service".
data",
Performing DVB-C signal generation tasks
on page 41.
Configuring the input signal
Chapter 4.2.1, "How to
38