Local Ip Data Network Settings - R&S SMCVB-K157 User Manual

®
R&S SMCVB-K157

3.7 Local IP data network settings

Access:
1. Select "Input Signal > General > Source > External".
2. Select "Input Signal > General > Input > IP"
3. Select "Input Signal > IP Channel x > Local IP Data Network".
The tab provides access to local IP data settings to configure the board address.
The remote commands to configure local IP data network settings are described in
Chapter 5.6, "BCIP
How to:
Settings:
Network
Restart
Hostname......................................................................................................................34
Address
IP Address.....................................................................................................................34
Protocol......................................................................................................................... 35
Subnet
Show
MAC
Network Status
Indicates that the instrument is connected to the network.
If the instrument is disconnected, try "Restart Network".
Remote command:
:SYSTem:COMMunicate:BCIP<hw>:NETWork:STATus
User Manual 1179.4686.02 ─ 01
subsystem",
Chapter 4.1.1, "How to apply an external IP input
Status..............................................................................................................33
Network............................................................................................................ 34
Mode............................................................................................................... 34
Mask................................................................................................................. 35
Connector............................................................................................................35
Address................................................................................................................ 35
DVB-C configuration and settings
on page 67.
Local IP data network settings
signal", on page 36
on page 69
33