Test Signal Commands - R&S SMCVB-K157 User Manual

®
R&S SMCVB-K157
Return values:
<InpSigUsefull>
Example:
Usage:
Manual operation:

5.2.3 Test signal commands

Example: Configuring test signal properties
SOURce1:BB:DVBC:SOURce TEST
SOURce1:BB:DVBC:TESTsignal TTSP
// Sets a test TS packet as test signal.
********************************************************************************
// Alternatively, set more specific test signals with PRBS parts within the
// test packet.
********************************************************************************
SOURce1:BB:DVBC:TESTsignal PBDE
// Inserts the PRBS sequence before the differential encoder.
SOURce1:BB:DVBC:TESTsignal PBEM
// Inserts the PRBS sequence after the mapper.
********************************************************************************
// Configure test signal properties.
********************************************************************************
SOURce1:BB:DVBC:TSPacket H184
SOURce1:BB:DVBC:PIDTestpack NULL
SOURce1:BB:DVBC:PID?
// Response in decimal representation: "8191"
// Response in hexadecimal representation: "1FFF"
SOURce1:BB:DVBC:PIDTestpack VAR
SOURce1:BB:DVBC:PID 4607
// Corresponds to "11FF" in hexadecimal representation.
SOURce1:BB:DVBC:PAYLoad PRBS
SOURce1:BB:DVBC:PRBS P23_1
[:SOURce<hw>]:BB:DVBC:TSPacket
[:SOURce<hw>]:BB:DVBC:PIDTestpack
[:SOURce<hw>]:BB:DVBC:PID
[:SOURce<hw>]:BB:DVBC:PAYLoad
[:SOURce<hw>]:BB:DVBC:PRBS
User Manual 1179.4686.02 ─ 01
float
Range: 0 to 999999999
Increment: 0.001
*RST: 0
See Example "Configuring general input signal properties"
on page 46.
Query only
See "Useful Data Rate"
.................................................................................52
.............................................................................52
......................................................................................... 52
..................................................................................52
...................................................................................... 53
Remote-control commands
on page 15
Input commands
51