®
R&S
SMCVB-K157
4 Performing DVB-C signal generation tasks
This chapter tells you how to configure the R&S SMCV100B to generate signals for
simple receiver tests.
●
Configuring the input
●
Monitoring the input
4.1 Configuring the input signal
This chapter provides an overview of the different input signals, that the
R&S SMCV100B uses as modulation data.
●
How to apply an external IP input
●
How to apply an external TS input
●
How to generate an internal TS
4.1.1 How to apply an external IP input signal
To connect the R&S SMCV100B to local IP data network
1. Connect the IP source to the "IP Data" connector of the R&S SMCV100B.
See chapter "Connecting to IP Data Interface" in the R&S SMCV100B Getting Star-
ted user manual.
2. Select "Input Signal > General > Source > External".
3. Select "Input Signal > General > Input > IP".
4. In the "IP Channel x" side tab, click "Local IP Data Network".
By default, the R&S SMCV100B assigns the IP address automatically using
("Address Mode > Auto (DHCP)").
5. If "Network Status > Disconnected", try "Restart Network".
User Manual 1179.4686.02 ─ 01
Performing DVB-C signal generation tasks
signal.....................................................................................36
signal...................................................................................... 41
signal................................................................. 36
signal................................................................39
signal.................................................................... 40
Configuring the input signal
DHCP
36