How To Apply An External Ts Input Signal - R&S SMCVB-K157 User Manual

®
R&S SMCVB-K157

4.1.2 How to apply an external TS input signal

To connect to the external TS input interface
1. Use a double-shielded 75 Ω BNC cable for connection between R&S SMCV100B
and the external
See also Section "Cable selection and electromagnetic interference (EMI)" in the
R&S SMCV100B Getting Started user manual.
2. At the R&S SMCV100B, connect the cable to the "User 1" connector.
The connector is on the rear panel of the R&S SMCV100B.
How to: Section "To connect to non-screwable connectors (BNC)" in the
R&S SMCV100B Getting Started user manual.
To specify the TS input interface at the R&S SMCV100B
The R&S SMCV100B is
nector.
1. Select "Input Signal > General > Source > External".
2. Select "General > Global Connectors".
3. In the "Global Connectors" dialog, configure the "User 1" connector for a TS input
signal:
a) Select "Direction > Input".
b) Select "Signal > TS".
To configure an external TS input signal
The R&S SMCV100B is
nector.
1. Specify general TS input signal properties:
a) Select "Input Signal > General > Source > External".
b) Select "Input > TS IN".
c) Specify the format of the input signal:
2. Optionally, activate "Stuffing" to adjust the TS data rate.
User Manual 1179.4686.02 ─ 01
MPEG TS data source.
connected
prepared
● Select "ASI", if you have a source supporting
● Select "SMPTE 310", if you have a source supporting
Performing DVB-C signal generation tasks
to an MPEG TS data source via the "User 1" con-
for receiving a TS input signal at the "User 1" con-
Configuring the input signal
ASI format.
SMPTE 310 format.
39