R&S SMCVB-K157 User Manual page 47

®
R&S SMCVB-K157
Example:
Manual operation:
[:SOURce<hw>]:BB:DVBC:INPut:FORMat <InpSigFormat>
Sets the format of the input signal.
Parameters:
<InpSigFormat>
Example:
Manual operation:
[:SOURce<hw>]:BB:DVBC:INPut:TSCHannel <InpSigTSChannel>
Selects the IP-based transport stream (TS) channel. You can select 1 out of 4 IP TS
channels as input at the "IP Data" interface.
To configure a particular channel, see
on page 17.
Parameters:
<InpSigTSChannel> 1 | 2 | 3 | 4
Example:
Manual operation:
[:SOURce<hw>]:BB:DVBC:STUFfing <InpSigStuffing>
Queries the stuffing state that is active.
Parameters:
<InpSigStuffing>
Example:
User Manual 1179.4686.02 ─ 01
TS
Input for serial transport stream data. The signal is input at the
"User 1/2" connectors.
IP
Input for IP transport stream data. The signal is input at the "IP
Data" connector.
*RST: TS
See Example "Configuring general input signal properties"
on page 46.
See "Input" on page 13
ASI | SMPTE
*RST: ASI
See Example "Configuring general input signal properties"
on page 46.
See "Input Format" on page 13
Chapter 3.2.4, "IP channel x
*RST: 1
See Example "Configuring general input signal properties"
on page 46.
See "IP TS Channel" on page 13
1 | ON
*RST: 1
See Example "Configuring general input signal properties"
on page 46.
Remote-control commands
Input commands
settings",
47