R&S SMCVB-K157 User Manual page 13

®
R&S SMCVB-K157
"TS Player"
"Test Signal"
Remote command:
[:SOURce<hw>]:BB:DVBC:SOURce
Input
Requires "Source > External".
Sets the external input interface.
"TS IN"
"IP"
Remote command:
[:SOURce<hw>]:BB:DVBC:INPut
Input Format
Requires "Input > TS IN".
Sets the format of the input signal.
"ASI"
"SMPTE 310"
Remote command:
[:SOURce<hw>]:BB:DVBC:INPut:FORMat
IP TS Channel
Requires "Input > IP".
Selects the IP-based transport stream (TS) channel. You can select 1 out of 4 IP TS
channels as input at the "IP Data" interface.
To configure a particular channel, see
on page 17.
Remote command:
[:SOURce<hw>]:BB:DVBC:INPut:TSCHannel
Stuffing
Requires "Source > External/TS Player".
Displays that stuffing is active.
The installed input interface provides the transport stream data rate required for the
current modulation parameters (regardless of the input data rate of the external trans-
port stream).
User Manual 1179.4686.02 ─ 01
Uses an internal transport stream with TS packet data played from a
file. The player requires no option.
Playing encrypted files with extension _c requires a stream library
option R&S SMCVB-KSx.
See also:
●
Chapter 3.6, "TS player",
●
Supported TS player file types
Uses an internal test signal as specified in
settings", on page 16.
on page 46
Input for serial transport stream data. The signal is input at the "User
1" connector.
Input for IP-based transport stream data (TSoverIP). The signal is
input at the "IP Data" connector.
on page 46
ASI format
SMPTE 310 format
Chapter 3.2.4, "IP channel x
DVB-C configuration and settings
Input Signal settings
on page 23
Chapter 3.2.3, "Test Signal
on page 47
settings",
on page 47
13