Seamless Loop Settings - R&S SMCVB-K157 User Manual

®
R&S SMCVB-K157
PID Test Packet
If a header is present in the test packet ("Test TS Packet > Head/184 Payload"), you
can specify a fixed or variable packet identifier (PID).
"Null"
"Variable"
Remote command:
:TSGen:CONFigure:PIDTestpack
PID (Hex)
Sets the PID.
If "PID Test Packet > Null", "PID (Hex) = 1FFF" is fixed.
If "PID Test Packet > Variable", you can edit the value.
Remote command:
:TSGen:CONFigure:PID
Payload Test/Stuff
Defines the payload area content of the
"PRBS"
"0x00"
"0xFF"
Remote command:
:TSGen:CONFigure:PAYLoad
PRBS
Sets the length of the PRBS sequence.
You can select a PRBS 15 or a PRBS 23 sequence as specified by
Remote command:
:TSGen:CONFigure:PRBS[:SEQuence]

3.6.3 Seamless loop settings

Displaying the tab requires a *.trp, *.trp_c, *.emc or *.emc_c file loaded into the
"TS Player" dialog. *.trp files are previously recorded files.
User Manual 1179.4686.02 ─ 01
The header of the test transport stream packets has a fixed setting of
null packet header 1FFF (hex).
Uses the header value defined with
on page 62
on page 61
PRBS data in accordance with
See also chapter "Internal Modulation Data" in the R&S SMCV100B
User Manual.
Exclusively 00 (hex) data
Exclusively FF (hex) data
on page 61
DVB-C configuration and settings
PID (Hex).
TS packet.
ITU-T O.151
on page 62
TS player
ITU-T O.151.
31