[:Source<Hw>]:Bb:input:ip<Ch>:Port; [:Source<Hw>]:Bb:input:ip<Ch>:Type; [:Source<Hw>]:Bb:input:ip<Ch>:Multicast:address - R&S SMCVB-K157 User Manual

®
R&S SMCVB-K157
Example:
Manual operation:
[:SOURce<hw>]:BB:INPut:IP<ch>:PORT <Port>
Sets the port of the input IP data at the "IP Data" connector.
Parameters:
<Port>
Example:
Manual operation:
[:SOURce<hw>]:BB:INPut:IP<ch>:TYPE <Type>
Sets the IP input type.
Parameters:
<Type>
Example:
Manual operation:
[:SOURce<hw>]:BB:INPut:IP<ch>:MULticast:ADDRess
Sets the destination IP address (IPv4) of the IP connection.
Parameters:
<Address>
Example:
Manual operation:
User Manual 1179.4686.02 ─ 01
See Example "Configure IP channel 2 properties"
See "Alias" on page 19
integer
Range: 0 to 65535
*RST: 6002
See Example "Configure IP channel 2 properties"
See "Port" on page 20
UNIcast | MULTicast
UNIcast
Analyzes all unicast IP packets that arrive at the specified port.
See
[:SOURce<hw>]:BB:INPut:IP<ch>:PORT
MULTicast
When an IP address is in the multicast address range, an
attempt is made to join a multicast group using IGMP. Set multi-
cast address and port.
See:
[:SOURce<hw>]:BB:INPut:IP<ch>:MULticast:ADDRess
on page 55
[:SOURce<hw>]:BB:INPut:IP<ch>:PORT
*RST: UNIcast
See Example "Configure IP channel 2 properties"
See "Type" on page 19
string
Range: 224.0.0.0 to 239.255.255.255
See Example "Configure IP channel 2 properties"
See "Multicast Address"
Remote-control commands
Input commands
on page 55
on page 19
on page 53.
on page 53.
on page 55.
on page 53.
on page 53.
55