General Settings - R&S SMCVB-K157 User Manual

®
R&S SMCVB-K157

3.2.1 General settings

Access:
► Select "Input Signal > General".
The dialog provides settings to configure the input signal. Also, it provides physical
layer information for external signals and transport stream (TS) signals. For internal
test signals, you can configure payload and structure of test packets.
Settings:
Source...........................................................................................................................12
Input.............................................................................................................................. 13
Input
IP TS
Stuffing.......................................................................................................................... 13
Test
Source
Sets the modulation source for the input signal.
"External"
User Manual 1179.4686.02 ─ 01
Format..................................................................................................................13
Channel...............................................................................................................13
Signal.....................................................................................................................14
Uses a transport stream, that is input at the "TS IN"/"IP Data" inter-
face.
For more information about connecting to the interfaces, see also:
●
"TS IN" interface: Section "Configuring the Global Connectors" in
the R&S SMCV100B user manual.
●
"IP Data" interface:
on page 33.
DVB-C configuration and settings
Chapter 3.7, "Local IP data network
Input Signal settings
settings",
12