Omron H3CR-A Manual page 243

H5S
Nomenclature
Front Panel (With Cover Open)
12. OUT ON/OFF
Switch
Time adjustment
mode indicator
Power failure
indicator
Output
Output indicator
Key Operations
No.
1 Shifts the cursor (B) specifying a day to the right.
2 Sets or cancels a specified day.
3, 4 Sets a time or ON/OFF time width.
5 Monitors the parameters set for an operation during an operation.
6 Sets parameters.
7 Sets a time adjustment mode.
8 Specifies a cyclic operation, or sets a pulse width.
9 Specifies a day substitution operation.
10 Cancels the parameters set for each circuit, or a day override operation.
11 P1: Circuit 1 setting mode
P2: Circuit 2 setting mode
RUN: RUN mode
12 ON: Turns on the output regardless of the setting.
AUTO: Execute an operation as specified.
OFF: Turns off the output regardless of the setting.
13 TIMER: Executes an ordinary timer or cyclic operation.
PULSE: Executes a pulse output operation.
14 Specifies an operation to be performed after power recovery (AUTO/MANUAL).
14. Boot selection
13. Output setting switch
Timing chart
display
Automatic operation
indicator
1. Shift Key
2. Set/Reset Key
3. h (hour) Key
4. m (minute) Key
5. Check Key
6. Write Key
11. Mode Switch
7. Time (time adjustment) Key
10. Clr (clear) Key
9. Copy Key
8. Cycle/Pulse Key
(Actual size)
Current day/operation day indicators
Display of current time/operation time/time width
Pulse width unit indicator
Display of number of remaining steps
Circuit
Circuit number
indicators
Function
H5S
243