Omron H3CR-A Manual page 170

H5BR
Output mode d: Signal OFF delay (Timer resets when power comes on.)
Power
Start signal
Gate
Reset
Control output
Set value
UP
0
Timing
diagram
Set value
DOWN
0
Output mode E: Interval (Timer resets when power comes on.)
Power
Start signal
Gate
Reset
Control output
Set value
UP
0
Timing
diagram
Set value
DOWN
0
Output mode F: Cumulative (Timer does not reset when power comes on.)
Power
Start signal
Gate
Reset
Control output
Set value
UP
0
Timing
diagram
Set value
DOWN
0
Batch Counter Operation
Batch count reset
Batch count
set
value
Batch count present
value 0
Batch output
1. The batch count present value remains at 0 while the batch
count reset is ON.
2. When the batch count set value is 0, the batch count will
proceed, but there will be no output.
3. When the batch count present value exceeds 9999, it returns
to 0.
4. The batch count present value and output are not affected by
RESET key or reset input.
5. When power is interrupted and the batch count output is ON,
the output will be ON when power returns.
6. When a batch count set value which is greater than the
present value is changed to a set value which is less than the
present value, the output will go ON.
170
The control output is energized at the
leading edge of the start signal.
Timing begins at the trailing edge of
the start signal. The control output is
de-energized when the present value
equals the preset time.
Timing begins on the leading edge of
the start signal. The control output is
only energized during timing. The
timer is reset when power is
interrupted or a reset signal is applied.
Timing begins on the leading edge of
the start signal. The control output is
energized when the cumulative
elapsed time of the start signal is
equal to the preset time. The output is
sustained until power is interrupted or
a reset signal applied.
The batch count output holds until
reset by the batch count reset.
The present value of the batch count
advances continuously.
7. If, after the output has gone ON, the set value is changed to a
set value which is greater than the present value, the output
will remain ON.
8. In the Flicker 1, 2 output hold modes, the number of
completed timing is double the number of outputs. To control
the number of outputs, set the batch count set value at double
the desired number of outputs.
H5BR