Omron H3CR-A Manual page 209

H5CN
Note
: 1. High-speed Repeat Operation Circuit
When resetting the timer using the reset input terminal, high-speed resetting is possible at a speed of 0.02 s. Accordingly, by using
two H5CN Timers, a high-speed repeat operation circuit can be created.
2. Integrating Operation
Use of the gate input terminal permits the timer to sum up timers T
Operating Time Measurement
The UP display timers with digital display can be used to measure
the operating time of other timers or equipment. (For this measure-
ment, set the set time to the maximum.)
Note: The digital display of H5CN stops incrementing
when the predetermined operating time of timer
"T" has elapsed.
H5CN
No. 1
, T
1
UP Display Timer
DOWN Display Timer
H5CN
No. 2
, and T (i.e., integrating operation) as shown below.
2 3
H5CN
209