Connectors And Cables; Mounting The Lumencor Spectra 6 Unit - 3DHISTECH Pannoramic 250 FLASH III User Manual

Pannoramic 250 FLASH III 3.0.2 User's Guide

2.3 Connectors and cables

Control – USB (between scanner and control computer)
•
Preview camera – USB cable (between scanner and control computer)
•
Adimec – CoaXPress cables (between Adimec camera and control computer)
•
pco.edge 4.2 – a pair of CameraLink cables (between pco.edge 4.2 camera and control
•
computer)
Point Grey Grasshopper 3 – USB 3.0 cable (between Point Goint Grey Grasshopper 3 camera
•
and control computer)
Video cable (between monitor and control computer)
•
Power supply cable (between 230V/110V and monitor)
•
Power supply cable (between 230V/110V and control computer)
•
Power supply cable (between 230V/110V and Pannoramic® 250 FLASH III main unit)
•
Trigger cable (between pco.edge 4.2 and Lumencor SPECTRA 6 fluorescent illumination unit)
•
USB-to-RS232 serial communication cable (between Lumencor SPECTRA 6 fluorescent
•
illumination unit and control computer)
Only connect external devices that are safety extra low voltage rated to
the instrument to avoid the risk of electrical shock.

2.4 Mounting the Lumencor SPECTRA 6 unit

To operate the Lumencor SPECTRA 6 unit, it has to be attached to the Pannoramic® 250 FLASH III base
unit.
1. Switch off the main power supply on the rear panel of the Pannoramic® 250 FLASH III and
disconnect the power cables (see chapter 1.1.4 Main parts of the Base Unit).
2. Open protective cover (see chapter 5.3.1 Opening the protective cover).
September 16, 2020 – Rev. 1
Warning!
3DHISTECH Ltd.
2.3 Connectors and cables
27(156)