Led Status Indicator; Status Led; Shutter Led - Christie GS 2K Series User Manual

LED status indicator

LED status indicator helps identify the projector state. LEDs are defined below.

Status LED

Identify the LED state colors and meaning.
LED status Projector state
Off AC power is off (without AC plugged in).
Green (flashing) Projector is starting up.
Green (solid) System is operating normally.
Blue (flashing) Projector is cooling down.
Blue (solid) Projector is in standby mode.
Yellow (flashing) A problem exists with the projector that does not cause it to shut down.
Examples of warnings include: filter needs changing, one of the pumps is damaged, or a
fan is operating at full speed due to over temperature of laser diode (LD) driver.
Yellow (solid) The end user is turning off the projector while it is in a warning state.
Red (flashing) An error with the projector exists causing it to shut down.
Examples of errors include: fan failure, over temperature, wrongly installed filter, or color
wheel (CW) failure.
Red (solid) The user is turning off the projector while it is in an error state.
White (flashing) Projector is in Firmware Upgrade Mode.

Shutter LED

Identify the shutter LED state colors and meaning.
LED Status Projector State
Off Projector is on and an image is displayed. Shutter is open.
Magenta (solid) Projector is on and the image is blank. Shutter is closed.
GS Series 2K User Manual - DWU880-GS, DWU880A-GS, DWU9200-GS, DWU1100-GS, DWU1100A-GS
020-001908-01 Rev. 1 (02-2022)
Copyright © 2022 Christie Digital Systems USA Inc. All rights reserved.
Installation and setup
26