Turning On The Projector; Turning Off The Projector - Christie GS 2K Series User Manual

Turning on the projector

The projector cables must be securely connected before turning the power on.
Warning! Failure to comply with the following could result in death or serious injury.
• Do not look into the projector lens when the laser is on. The bright light may result in permanent
eye damage.
• Installing or replacing a lens must be done by a Christie-qualified service technician to avoid
exposure to dangerous emission levels.
1. Plug the projector in to AC power.
The Power button on the built in keypad is illuminated when the power cables are connected.
2. Ensure the lens has been installed in the projector by a Christie-qualified service technician.
3. Ensure that no one or no objects are in the beam path before turning on the projector.
4. To turn on the projector, on the IR remote keypad on the built-in keypad press
The status LED is green with a long blink.
5. To select an input source and turn it on, on the IR remote keypad select INPUT.
Available input sources are VGA, HDMI1, HDMI2, DVI, 3G-SDI, 3D sync, and HDBaseT.
The projector detects the source you selected and displays the image.
6. If using the projector for the first time, select a preferred language from the Main Menu after
the startup screen is displayed.

Turning off the projector

Power off the projector in preparation for inspection or maintenance.
1. To turn the projector off, on the IR remote keypad or built-in keypad press
A warning message appears on the displayed image.
2. To confirm your selection, press
If you do not press
projector remains on.
GS Series 2K User Manual - DWU880-GS, DWU880A-GS, DWU9200-GS, DWU1100-GS, DWU1100A-GS
020-001908-01 Rev. 1 (02-2022)
Copyright © 2022 Christie Digital Systems USA Inc. All rights reserved.
again.
again, the warning message disappears after three seconds and the
Installation and setup
.
.
25