Table of Contents
Advertisement
If not fully retracted and latched back: Shorten the cable length until the CDX-10 bolt retracts and latches back just before
the Rim Exit Device latch bolt clears its strike.
If fully retracted and latched back: With the door open, depress the panic bar until the CDX-10 bolt retracts and latches
back. Depress the CDX-10 bolt reset latch to allow the CDX-10 bolt to extend. Check to see if the pulley restores clockwise
sufficiently to prevent the CDX-10 bolt from being pushed back. (A thin-blade screwdriver may be inserted between the end of
the bolt and the bolt guard for the purpose of pushing back on the bolt.) If the CDX-10 bolt can be pushed back, slightly
increase the cable length and recheck the CDX-10 bolt latching status by following the directions above.
C.
Finger tighten nut. Then using the wrench tighten down nut 1/8-1/4 turn max (30-40 in-lb). Do not exceed 50 in-lb, this may
result in failure.
D.
Adjust the CDX-10 strike so that the throat of the strike has minimum clearance of the bolt guard when the door is contacting
the jamb.
E.
Assure no load on the CDX-10 bolt, from the strike, (There should be no touching of the bolt against the strike.) mark and
transfer punch the remaining (3) screw locations for the CDX-10 strike.
F.
Install the remaining (3) screws. Ensure proper and correct function/location of both lock systems.
G.
Ensure proper function of all lock systems before continuation of cover installation.
and Latched Back
Figure 27- Position of CDX-10 Bolt Fully
Retracted and Latched Back (Top View LHR
Shown)
Covers
Install Chassis Cover
A.
Locate the universal chassis cover (515030) and
B.
Orient the universal chassis cover, as it will be installed, based on door handing, and slide the
chassis cover.
C.
Position the universal chassis cover over the Rim Exit Device, aligning the cover cutouts to fit over the chassis. Locate the
cover flush to the surface of the door and bias the cover away from the door edge.
D.
Secure the universal chassis cover to the Rim Exit Device using four (4) #8-32 x
Figure 29
Door
Rim Exit Device Latchbolt
Figure 28 - Position of Latch bolt Just Prior
to Clearing Strike (Top View LHR Shown)
end cap.
Universal Chassis
Cover
(515030)
"
5
(4) #8-32 X
/
16
screws
(105034)
End Cap
(515038)
35
Door
end cap
into the universal
" PHMS (105034) screws.
5
/
16
35
Advertisement
Table of Contents
