Test The Operation Of The Outside Lever - Kaba Mas DKX Series Installation Instructions Manual

Hide thumbs

Table Of Contents

Table of Contents

Remove the key. (The lock will look as shown at right.)

Gently check the rotation of the lever handle.

(It should easily rotate approximately 45º.)

Troubleshooting: If you have assembled the lever and housing

with the key in the wrong position, the key will get stuck. To

remove the key, turn it so that it is in the vertical position and

insert a small flat screwdriver into the hole under the lever handle

to push the lever catch in (f). Remove key. If it is still stuck, turn the

key clockwise until it stops to the horizontal position and push the

lever catch in again with the small screwdriver. Remove key.

Troubleshooting:

Right-handed Lock: Turn the lever handle clockwise without forcing it. If it stops at

approximately 15º, it was not assembled correctly. Do not try to force it to turn—this

will damage the inside mechanism of the lock. Release the lever handle. Insert the

small screwdriver into the small hole on the underside of the lever handle and push in

the lever catch.

Re-do steps A-C in Phase One/Section E- Install the Outside Lever of dormakaba

PowerPlex P2000.

Left-handed Lock: Turn the lever handle counterclockwise without forcing. The drive

hub should not rotate when the lever handle is turned. If it does, it was not assembled

correctly. Release the lever handle. Insert the small screwdriver into the small hole on

the underside of the lever handle and push in the lever catch.

Re-do steps A-C in Phase One/Section E- Install the Outside Lever of dormakaba

PowerPlex P2000.

Use the

while pushing the lever against the plastic

washer to remove the lever play.